Rear TRD Stainless Steel Brake Line Install
Page 3
It's pretty easy to figure out which part of the line bolts up to this part of the system. You need to slide it through the bracket, then thread in the flare nut.
You need to line up the new brake line like how the stock brake line was installed. When you have the parts in hand, it will make sense.
You need to use the 17mm wrench on the bottom piece (Just above the "E" Clip.) so you can tighten the flare nut properly.
When installing the bottom union bolt, use the NEW gaskets provided by
TRD...
they're just like washers.